The dry powder mortar mixer generally adopts impeller mixing. The dry powder mixer is equipped with an auxiliary air suction outlet. The air suction outlet is properly opened through the regulating plate to form a negative pressure in the mixing room when the mixer works, which is conducive to the timely discharge of things after mixing from the screen.

如果调节板开度过小，进风量不大，搅拌室内的负压小，搅拌物排出不畅，搅拌物过度粉碎，搅拌室内的热量不能及时排出，搅拌机必然“发烧”。干粉砂浆搅拌机“发烧”时，必须检查调节板的开度。

If the opening of the regulating plate is too small, the air inlet volume is small, the negative pressure in the mixing room is small, the mixing material is not discharged smoothly, the mixing material is excessively crushed, and the heat in the mixing room cannot be discharged in time, the mixer must have a "fever". When the dry powder mortar mixer "has a fever", the opening of the regulating plate must be checked.

搅拌物料沉降室的空间要尽量大，有利于搅拌物料顺利及时的排出。所以在设计时应预留适当空间以满足工艺要求。

The space of mixing material settling chamber shall be as large as possible, which is conducive to the smooth and timely discharge of mixing materials. Therefore, appropriate space should be reserved in the design to meet the process requirements.

因干粉砂浆搅拌机锤片高速旋转打击、磨擦物料，物料中的水分和微细粉尘会被脉冲除尘器布袋粘附，风阻增加，随着时间的增长，除尘器的风量和风压会有所损失，严重时会使粉碎机“发烧”，产量降低，必须及时更换或者清洗除尘器的布袋。

Due to the high-speed rotation of the hammer blade of the dry powder mortar mixer to strike and rub the materials, the moisture and fine dust in the materials will be adhered by the cloth bag of the pulse dust collector, and the wind resistance will increase. With the increase of time, the air volume and air pressure of the dust collector will be lost. In serious cases, the pulverizer will "fever" and the output will be reduced. The cloth bag of the dust collector must be replaced or cleaned in time.

干粉砂浆搅拌机使用不当，长期处于超负荷状态下工作，也会引起搅拌机发烧，甚烧电机。正确的工况是电机工作在90%的额定负载下。在正确的分析了干粉砂浆搅拌机的“发烧”磨损原因后，我们可以积极的改正，维护保养好干粉砂浆搅拌机。

If the dry powder mortar mixer is used improperly and works under overload for a long time, it will also cause the mixer to have a fever and even burn the motor. The correct working condition is that the motor works at 90% of the rated load. After correctly analyzing the "fever" wear causes of dry powder mortar mixer, we can actively correct and maintain the dry powder mortar mixer.

本文由小型搅拌机友情奉献.更多有关的知识请点击:https://www.zishangliaojiaobanji.cn 真诚的态度.为您提供为的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.

This article is dedicated by the small mixer. For more information, please click: https://www.zishangliaojiaobanji.cn  Sincere attitude. To provide you with a comprehensive service. More relevant knowledge, we will continue to offer to you. Please look forward to it