自上料搅拌车在起步行走前，应对所有的操纵手柄、踏板、方向盘先试一次，确定已处于正常状态才能开始进入作业。自上搅拌铲车正常使用注意事项：控制轮胎充气压力轮胎气压过高或低均会导致轮胎早期磨损，严重影响轮胎的使用寿命。检查水泵一风扇传动皮带，皮带经长期使用后，皮带会产生疲劳、变形，降低冷却效果。皮带更换时，要注意型号和长度，并正确调整其松紧度。

Before starting the loading mixer, all operating handles, pedals and steering wheel shall be tested first to confirm that they are in normal state before entering the operation. Precautions for normal use of self mixing forklift: control the tire inflation pressure. High or low tire pressure will lead to early tire wear and seriously affect the service life of the tire. Check the water pump fan drive belt. After long-term use, the belt will be tired and deformed, reducing the cooling effect. When replacing the belt, pay attention to the model and length, and correctly adjust its tightness.

1、更换前后桥齿轮油（之后每1000小时更换）；

1. Replace the front and rear axle gear oil (every 1000 hours thereafter);

2、清洗柴油箱的吸油滤网；

2. Clean the oil suction screen of the diesel tank;

3、清除水箱、散热器表面的污染物；

3. Remove pollutants on the surface of water tank and radiator;

4、更换发动机机油，更换机油、柴油油滤清器；

4. Change engine oil, engine oil and diesel oil filter;

5、更换变速箱油和油滤清器；

5. Replace the transmission oil and oil filter;

6、检查发动机气门间隙。

6. Check the engine valve clearance.

自上料搅拌车用户购买多大载重量的自上搅拌铲车要本着实用够用的原则，不用于挖掘用于搬运大量松散材料根据作业量的大小来确定：既不能过大也不能过小，过大造成浪费、过小则不够使用。变速箱滤清器堵塞液力传动油滤清器堵塞，致使供油不畅，也会导致变速箱油压过低，应查找堵塞原因，及时更换新的油液和滤清器。

The self loading mixer forklift with a large load capacity purchased by the user shall be based on the principle of practicality and sufficiency, and shall not be used for excavation and handling a large amount of loose materials. It shall be determined according to the operation volume: it shall not be too large or too small, which will cause waste and too small will not be enough for use. The transmission filter is blocked and the hydraulic transmission oil filter is blocked, resulting in poor oil supply and low transmission oil pressure. Find out the cause of the blockage and replace the oil and filter in time.