Small blender usually when we use it will be well maintained, of course, there will be regular cleaning work to do, so it is necessary to remove the machine, so do you know how to remove the small blender safely? Let's take a look at it briefly.

　　拆装小型搅拌机时，先拆下搅拌机三角带，拆下四个固定螺丝，即可轻松拆下电机。使用拨盘卸下电机上的皮带。卸搅拌机电机时，先拆下搅拌机上的八颗螺丝，再拆下固定搅拌机，放在地上。注意搅拌机比较重，需要三四个人才能搬动。小心不要受伤。

　　When disassembling the small mixer, first remove the mixer triangle belt, remove the four fixing screws, and then easily remove the motor. Use the dial to remove the belt from the motor. To remove the mixer motor, remove the eight screws on the mixer, then remove the fixed mixer and place it on the ground. Note that the blender is heavy and takes three or four people to move. Be careful not to get hurt.

　　拆卸破碎叶轮时，先拆下破碎叶轮的四个固定螺钉。采集过程中注意轻轻摇晃，慢慢取出，以免叶轮变形，否则会影响使用。拆卸清洗后，安装时，安装电机时，应将电机缓慢倒置放入小型搅拌机中。安装后应进行空机试运行，确保设备无异常后方可继续使用。

　　When disassembling the broken impeller, first remove the four fixing screws of the broken impeller. In the process of collection, pay attention to gently shake and take out slowly to avoid impeller deformation, otherwise it will affect the use. After disassembly and cleaning, when installing the motor, the motor should be slowly inverted into a small blender. After installation, empty machine test operation should be carried out to ensure that the equipment is normal before continuing to use.

　　另外为保证设备操作人员进行日常维护保养，规定操作人员在每班下班前和节假日前一定时间内对饲料厂设备进行维护保养。 对不能停机连续运行的饲料厂设备，要及时擦拭、检查和保养，完成保养规程规定的工作内容并达到要求。

　　In addition, in order to ensure the daily maintenance of equipment operators, operators are required to maintain the feed factory equipment within a certain period of time before each shift and holidays. The feed factory equipment that cannot be shut down and run continuously should be wiped, inspected and maintained in time to complete the work content stipulated in the maintenance regulations and meet the requirements.

　　小型搅拌机设备内外清洁，无锈迹，工作场地清洁、整齐，地面无油污、垃圾；加工件存放整齐。各传动系统工作正常；所有操作手柄灵活、可靠。润滑装置齐全，保管妥善、清洁。防护装置完整、可靠，内外清洁。

　　Small mixer equipment inside and outside clean, no rust, work site clean, tidy, no oil, garbage ground; Processing parts are neatly stored. All transmission systems work normally; All operating handles are flexible and reliable. Lubrication device is complete, properly kept and clean. Safety protection device is complete, reliable, clean inside and outside.