自上料搅拌车遇到发烫、进水、潮湿返潮、长期连续工作都会引起大大小小的问题，如果出现一丝故障请立马停止使用。下面来讲讲自上料搅拌车在运输过程中需注意的问题。

The self feeding mixer will cause large and small problems in case of scalding, water ingress, moisture regain, and long-term continuous operation. If there is any fault, please stop using it immediately. Now let's talk about the problems that should be paid attention to during the transportation of the self loading mixer.

千万不能让自上料搅拌车坏在路上，否则出现闷罐就麻烦了，混凝土一般停罐不能超过2个小时，C40往上级别的混凝土基本就不能停。

Never let the self feeding mixer truck break down on the road, or it will be troublesome if the tank is stuffy. Generally, the concrete can't be stopped for more than 2 hours, and the concrete of C40 level can't be stopped basically.

点火之前先检查机油、防冻液、润滑油和冷却水等，发现不足时，应重新进行添加。车子启动后，再让罐子低速旋转，围绕着车检查轮胎气压，是否有漏气的胎，再用螺丝刀剔掉在胎缝里的石子，检查是否有铁钉之类扎在胎里!

Before ignition, check the engine oil, antifreeze, lubricating oil and cooling water, and add them again if insufficient. After the car starts, let the tank rotate at a low speed. Check the tyre pressure around the car to see if there is a flat tyre. Then use a screwdriver to remove the stones in the tyre seams and check if there are nails or something!

再检查灯光，尤其是腰灯，务必保证照着轮胎边缘，工地会经常乱堆放钢筋之类的东西，而胎侧是薄弱的。用抹布擦干净两边的后视镜，窗户玻璃，工地路况复杂，光线不好，视线一定要保证!

Check the lights again, especially the waist lights. Make sure to shine on the edge of the tire. The construction site will often pile up reinforcement and other things, and the tire side is weak. Wipe the rear-view mirrors and window glass on both sides with a rag. The road conditions on the construction site are complex and the light is bad. The sight must be guaranteed first!

保证水箱里有足够的水，有减水剂，因各种原因料太干，没有水添加放不出料的时候，减水剂就是救命稻草了。确认搅拌罐处于停止状态，因为发动机启动时万一罐子处于高速旋转状态，瞬间的力会很大的，伤减速机。

Make sure there is enough water and water reducer in the water tank. The material is too dry for various reasons. When there is no water to add and the material cannot be discharged, the water reducer is a lifesaving straw. Make sure that the mixing tank is stopped, because if the tank is rotating at a high speed when the engine is started, the instantaneous force will be great, which will hurt the reducer.

无论是将手柄从搅拌到排放还是从排放到搅拌，都应使其停止在停止位置，然后拨到下一个操作位置。您还有什么注意事项想得到确认，就来我们网站https://www.zishangliaojiaobanji.cn咨询吧！

Whether the handle is moved from mixing to discharging or from discharging to mixing, it should be stopped at the stop position and then moved to the next operation position. If you want to confirm any other precautions, please come to our website https://www.zishangliaojiaobanji.cn Consult!