一旦发现混凝土开始凝结，在报备负责人之后立刻进行卸料自动，自动上料搅拌车防止粘罐的方法以防整个罐体报废。减少车辆行驶时间混凝土运距一般在直径30千米范围以内，出车之前规划好路线以及车辆通行情况。
Once it is found that the concrete begins to set, the automatic unloading shall be carried out immediately after reporting to the person in charge, and the automatic feeding mixer shall be used to prevent the tank from sticking, so as to prevent the whole tank body from being scrapped. To reduce the driving time of vehicles, the concrete transportation distance is generally within the range of 30 km in diameter, and the route and traffic conditions of vehicles shall be planned before driving.
 要检查罐内水量每次出车任务完成回到站内的时候，检查储水罐内的水量，让水罐中的水随时处于满罐的状态，以备不时之需。随车带上减水剂：减水剂是一种在维持混凝土坍落度不变的条件下，能减少拌合用水量的混凝土外加剂，随车携带，能对混凝土进行很好的调节。离厂前检查混凝土质量：可能会因为原料的不同，每一盘混凝土质量都会有变化。
It is necessary to check the water volume in the tank. When returning to the station after the completion of the vehicle dispatching task, the water in the water storage tank should be checked to make the water in the water tank full at any time in case of emergency. Water reducer with vehicle: water reducer is a kind of concrete admixture which can reduce the water consumption of mixing under the condition of maintaining the concrete slump unchanged. It can adjust the concrete well when carried with the vehicle. Check the concrete quality before leaving the factory: the quality of each concrete plate may change due to different raw materials.

 搅拌机按所需砼配比确定供水量，并调节时间续点器到相应的给水时间。启动混凝土搅拌机的搅拌电机运转。关闭卸料门，在料斗内加入所需的混合料，提升料斗，料斗应运行平稳并能自如地停止在轨道的任意位置，若有打滑现象，应先将料斗放入坑底，然后调整制动电机的大螺母，料斗提升正常，制动可靠后向搅拌筒内投料同时启动水泵向搅拌筒内供水。在混凝土搅拌机搅拌25-35S后，启动卸料门卸料。
The mixer shall determine the water supply according to the required concrete proportion, and adjust the time repeater to the corresponding water supply time. Start the mixing motor of the concrete mixer. Close the discharge door, add the required mixture in the hopper, lift the hopper, the hopper should run smoothly and stop at any position of the track freely. If there is slippage, the hopper should first be put into the bottom of the pit, then the large nut of the brake motor is adjusted, the hopper is lifted normally, and after the operation is reliable, the feed is fed into the mixing drum, and the water pump is started to supply water to the mixing drum. After mixing for 25-35s in the concrete mixer, start the discharge gate to unload.
感谢您的阅读，此文的文章来源：自上料搅拌机更多的内容和问题请点击：https://www.zishangliaojiaobanji.cn/我们会继续努力的为您提供服务，感谢您的支持！
Thank you for your reading. This article is from the charging mixer. For more information and questions, please click: https://www.zishangliaojiaobanji.cn/ We will continue to work hard to provide services for you, thank you for your support!