1. The influence on the material quality of self mixing truck can not be ignored. Good materials in the use of a certain degree of corrosion resistance, pressure resistance and small resistance.

2.除材料外，还应注意自行搅拌车过滤器的端盖与金属之间的接触。

2. In addition to materials, attention should also be paid to the contact between the end cover of the filter of the self mixing truck and the metal.

3.在购买过程中，有必要在一定程度上了解自动饲料混合机的滤芯是否可以回收，是否可以用水清洗等，以及其使用寿命和使用

3. In the purchase process, it is necessary to know whether the filter element of the automatic feed mixer can be recycled, whether it can be cleaned with water, and its service life and use

自行搅拌车这种机械设备需要经常润滑，以在长期使用中保持良好的运行性能。那么，向设备中添加润滑剂时需要注意什么：

This kind of mechanical equipment of self mixing truck needs to be lubricated frequently to maintain good operation performance in long-term use. What should be paid attention to when adding lubricant to the equipment:

1.在操作过程中，请勿修理或润滑自行搅拌车。

1. Do not repair or lubricate the self mixing truck during operation.

2.定期向每个润滑脂接头中添加黄油，每4小时用轴端密封圈润滑一次油，并每周排干一次。

2. Add grease to each grease joint regularly, lubricate the oil with shaft end sealing ring every 4 hours, and drain off once a week.

3.使用自行搅拌车后，如有必要，在每个润滑点添加必要的润滑剂（辊轴，辊，钢丝绳，其他有效部件）。

3. After using the self mixing truck, if necessary, add necessary lubricant (roller shaft, roller, wire rope, other effective parts) at each lubricating point.

4.自行搅拌车减速器的齿轮和轴承利用齿轮旋转将油吹到油箱的内壁并流入轴承进行润滑。变速箱油位必须保持在油量表的两条线之间。如果油位太高或太低，则各个零件的温度可能会升高，润滑可能会减少，功率损耗可能会增加，并且机器操作可能会减少。

4. The gear and bearing of the reducer of the self mixing truck blow the oil to the inner wall of the oil tank and flow into the bearing for lubrication. The transmission oil level must be maintained between the two lines of the oil gauge. If the oil level is too high or too low, the temperature of individual parts may increase, lubrication may be reduced, power loss may increase, and machine operation may be reduced.

5.由自行搅拌车选择的润滑剂没有比粘度和粘度温度特性，凝固点低，氧化稳定性好，机械杂质和水分，腐蚀和磨损材料。其质量指标必须符合标准。

5. The lubricant selected by the self mixer has no specific viscosity and viscosity temperature characteristics, low freezing point, good oxidation stability, mechanical impurities and moisture, corrosion and wear materials. The quality index must meet the national standard.

自行搅拌车用于润滑，减少磨损并延长部件寿命。但是，在添加润滑剂的过程中要注意一些要点。为了测试过程中尚未彻底清洁的灰尘，必须每150小时和300小时更换一次新机器。工作时，请始终检查油位并及时添加。

The self mixing truck is used for lubrication, reducing wear and prolonging the service life of components. However, some important points should be paid attention to in the process of adding lubricant. In order to remove dust that has not been thoroughly cleaned during the test, a new machine must be replaced every 150 hours and 300 hours. When working, always check the oil level and add it in time.